How to Choose the Right Cap Seam and Specimen for Pull Testing

Mục lục

For a cap seam pull test, mark the section that takes the load when someone puts on, adjusts or removes the cap. Record the direction of the load and the type of failure to check before choosing a test.

Which specimens can be used for a seam pull test?

The grab method uses clamps that grip part of the specimen width. The machine pulls perpendicular to the seam at a constant rate of extension to determine the maximum force. ISO 13935-2:2026.

The method applies to straight seams, mainly in suitable woven fabrics. If the seam around the base of the crown is curved, mark the section so the lab can propose a check for that construction.

Illustration of a fabric specimen with a straight seam beside a finished cap
A flat sewn specimen for comparing seam construction and locating the section to check on the cap.

Choose a specimen based on where the load falls

SituationSpecimen or component to prepareWhat to record
Compare two seam constructionsTwo straight-seam specimens made from the same fabric, if feasible.Thread type, seam construction and any detail that changed between specimens.
Check the curved seam at the base of the crownA finished cap with the seam section marked.Where the load is applied and the test method recommended by the lab.
Check the buckle or adjustment strap attachmentThe sewn buckle or strap assembly from the sample.Pull direction, where to hold the sample and signs of failure to look for.
Comparing seam constructions and checking a cap during use may call for different methods.

Read the force measurement alongside the failure mode

Ask the lab to record the specimen ID, pull direction, preparation and failure mode. Report broken thread, fabric tearing along the stitch line and separation of the two fabric edges separately.

Use comparable test conditions where possible and keep before-and-after photos. If a straight specimen represents the seam construction, identify that specimen in the results.

From the TACS production team

Use separate report entries for straight-seam force testing and a pull check at the buckle attachment. Each result answers a different question about the sample.

Facebook
Twitter
Telegram
Email
Related news
Scroll to Top